GB3CN Repeater in West Wales IO71TX - 145.6875MHz - 94.8Hz CTCSS. Allstar Node 51993 & Echolink Node 1509
GB3CN, West Wales IO71TX - 145.6875MHz - 94.8Hz CTCSS. Allstar Node 51993 & Echolink Node 1509
Q. How do I use the link facilities? A. The DTMF commands shown on the index page are a good start, check the frequency is not in use, then key your microphone and send a command. GB3CN is connected to the Allstar Network and regularly connected to HUBNet. If you hear a QSO or a call, just respond or break in as you would normally. Q. How do I check my own audio? A. Connect to the Parrot Server by sending the DTMF command *59 Q. Can I join an existing QSO? A. Of course, break in as you usually would, giving your Callsign. Bear in mind that there will be a slight delay because of the magic of the internet (stations should leave an additional pause between overs) Q. There are remote stations connected and I want to connect elsewhere, can I disconnect them? A. Yes, wait for a pause and send the relevant DTMF command (shown on the index page). The DTMF shortcut has the disconnect command built in. Q. I see a command for HubNet, what is it? A. HubNet is a collaboration of lots of different links, from all kinds of platforms and modes, you can read about it HERE
Q: Is GB3CN a normal analogue Repeater? A: Yes, it just so happens that it is also connected to HUBNet. It is important that your radio is set to narrow FM and that you leave a pause between overs.
Q: Can I disconnect HUBNet and use GB3CN locally ? A: Yes, although there are other Repeaters in the area that fill that need. See the DTMF commands shown on the index page
GB3CN - West Wales IO71TX - 145.6875MHz - 94.8Hz CTCSS. Allstar 51993 & Echolink 1509
Q. How do I use the link facilities? A. The DTMF commands shown on the index page are a good start, check the frequency is not in use, then key your microphone and send a command. GB3CN is now connected to the Allstar Network and regularly connected to HUBNet. If you hear a QSO or a call, just respond or break in as you would normally. Q. How do I check my own audio? A. Connect to the Parrot Server by sending the DTMF command *59 Q. Can I join an existing QSO? A. Of course, break in as you usually would, giving your Callsign. Bear in mind that there will be a slight delay because of the magic of the internet (stations should leave an additional pause between overs). Q. Why are some stations louder than others. A. This is down to the audio settings of their own set up or the Link/Repeater they are working through Q. There are remote stations connected and I want to connect elsewhere, can I disconnect them? A. Yes, wait for a pause and send the relevant DTMF command (shown on the index page). The DTMF shortcut to move to another location has the disconnect command built in. Q. I see a command for HubNet, what is it? A. HubNet is a collaboration of lots of different links, from all kinds of platforms and modes, you can read about it HERE
GB3CN, West Wales IO71TX - 145.6875MHz - 94.8Hz CTCSS. Allstar Node 51993 & Echolink Node 1509
Q: Is GB3CN a normal analogue Repeater? A: Yes, it just so happens that it is also connected to HUBNet. It is important that your radio is set to narrow FM and that you leave a pause between overs.
Q: Can I disconnect HUBNet and use GB3CN locally ? A: Yes, although there are other Repeaters in the area that fill that need. See the DTMF commands shown on the index page